After partitioning is complete, the informational "Building New File System" screen appears for your inspection:
Creating ext3 on /dev/hda1
Creating xfs on /dev/hda2
Creating swap on /dev/hda3
Creating xfs on /dev/hda5
Mounting File systems:
/dev/hda2 at /newroot/
/dev/hda1 at /newroot/boot
/dev/hda5 at /newroot/home
/dev/hda3 as swap
NOTE: To see the output of 'mke2fs' and 'mkswap' for each partition, change to virtual terminal three (vt3, press the Alt+F3 key combination to get there). Change back to vt1 (Alt+F1) to see the installation menu again. Syslog information is available on vt4 (Alt+F4).
To continue installing, follow the instructions when they appear at the bottom of the screen:
Press [ENTER] to continue...
to move on, in this case back to the "Installation and Configuration menu" screen.